丢翻图方x2 + a2=2yn解法的计算研究

本文研究了一类丢番图方程的解.利用对Thue方程解的估计和方程解的连分式展开,获得了所求丢番图方程解的个数、解上界的估计和一般的求解算法.最后利用该算法给出了1≤a≤108的所有解.     

大视场光学遥感器焦平面板的研制

焦平面板作为承载TDICCD器件的部件,其强度、动静态刚度、热稳定性直接影响到遥感器的成像质量.针对目前光学遥感器大视场、宽覆盖的发展趋势,设计了一种新型的焦平面板.选用性能指标优良的高体份SiC/Al复合材料,既满足了结构设计指标的要求,同时又大大降低了产品重量.通过有限元模拟仿真分析和相关试验,验证了设计方案的可行...     

半透明介质相变中的辐射变物性问题

半透明介质相变传热在许多工程领域引起关注,其实质是变物性条件下伴随相变的辐射-导热瞬态耦合传热问题,其难点在于相变过程中的辐射变物性问题,尤其是折射率的时空演变问题.本文首次研究相变过程中的变折射率问题.假设相变介质存在固相-糊状-液相区,固/糊界面、液/糊界面假定为半透明漫反射.采用多层辐射传递模型模拟相变介质内的辐...     

高体分SiC_p/Al复合材料螺纹性能的测试

从SiCp/Al复合材料性能分析着手,讨论了预置件法、焊接法和粘接法等在空间遥感器研制中常用的联接方法的优缺点,提出了在高体积分数(体分)SiCp/Al复合材料上直接加工螺纹,并加装钢丝螺套的方法来改善螺纹联接性能。对在某高体分SiCp/Al复合材料上加工的M4、M5螺纹进行了拉伸测试,结果表明:加装钢丝螺套前,复合材料螺纹有被拉脱现象;加装钢丝螺套后,M4螺纹、螺杆在3 000～4 000 N被拉断;M5螺纹、螺杆在8 000～9 000 N被拉断,测试后两种规格的螺纹状态良好,可以满足实际应用对该材料拉伸强度的要求,其已应用于工程项目中。     

Recombination analysis of autosomal short tandem repeats in Chinese Han families

Recombination fractions between forensic STRs can be extrapolated from the International HapMap Project, but the concordance between recombination fractions predicated from genetic maps and derived from observation of STR transmissions in families is still ambiguous for autosomal STRs because of limited family studies. Therefore, the main goal of this study is to compare recombination fractions estimated by pedigree analysis with those derived from HapMap phase SNP data. Genotypes of nine autosomal STR pairs (TPOX‐D2S1772, D5S818‐CSF1PO, D7S3048‐D7S820, D8S1132‐D8S1179, TH01‐D11S2368, vWA‐D12S391, D13S325‐D13S317, D18S51‐D18S1364, and D21S11‐PentaD) from 207 two‐generation families with two to five children (the number of families with five, four, three, and two children was 2, 3, 20, and 182, respectively) were used to analyze the recombination. The linkage analysis showed that significant linkage was observed at six STR pairs (D5S818‐CSF1PO, D8S1132‐D8S1179, TH01‐D11S2368, vWA‐D12S391, D13S325‐D13S317, and D18S51‐D18S1364) with genetic distances <36.22 cM in HapMap. Their recombination fractions calculated from family data were very close to those derived from HapMap. However, three STR pairs of TPOX‐D2S1772, D7S3048‐D7S820, and D21S11‐PentaD showed no significant linkage with genetic distances from 43.38 to 91.49 cM. Our results indicate that recombination fractions extrapolated from HapMap can provide a substitute if empirical data are unavailable for the linkage STR pair with a genetic distance spanned <36.22 cM.     

Ultrasonic devulcanization of waste rubbers: Experimentation and modeling

Continuous ultrasonic devulcanization of ground tire rubber (GRT) and styrene-butadiene rubber (SBR) is considered. Experiments are performed under various processing conditions. Two recipes of SBR with different amounts of polysulfidic linkages are utilized. Gel fraction and crosslink density of devulcanized rubbers are measured and a unique relationship between them is established. Die characteristics with and without imposition of ultrasonic waves are determined. Devulcanized samples are revulcanized and mechanical properties are measured. In some cases, properties of revulcanized SBR samples exceeded those of virgin vulcanizates. This is explained based on the presence of a double network in the revulcanized rubber. A modification of acoustic cavitation and flow modeling of ultrasonic devulcanization of SBR and GRT is proposed using a concept of effective viscosity characterizing the flow of vulcanized particles before devulcanization combined with a shear rate, temperature and gel fraction-dependent viscosity of devulcanized rubber. Velocity, shear rate, pressure, and temperature field along with gel fraction, crosslink density and number of bonds broken are simulated. Predicted data on gel fraction, crosslink density, and pressure using the present modification of the model are found to be closer to experimental data then previously reported.Dedicated to the memory of Professor Tasos C. Papanastasiou     

液态金属熔池中气泡-液体两相湍流的数值模拟研究

应用欧拉-欧拉双流体模型,以及分别描述气泡和液体湍流的两相湍流模型,描述液态金属中气体射流发泡过程的两相流动及气泡分布。与实验结果的对比表明,本模型的预测能力优于前人未考虑气相湍流的模型。考查了液体物性和气泡尺寸对流场特性的影响,结果发现,液体密度越低,气泡尺寸越小,气泡分布就越均匀。     

Significance of Photosensitized Oxidation of Alkanes During the Photochemical Degradation of Petroleum Hydrocarbon Fractions in Seawater

Abstract

A crude oil hydrocarbon fraction was photooxidized as a surface film on seawater under simulated environmental conditions. After irradiation, gas chromatography and gas chromatography/mass spectrometry analyses allowed to demonstrate the presence of relatively high quantities of compounds deriving from the photosensitized oxidation of n-alkanes, pristane and phytane, being among the non-acidic photoproducts of this fraction. The results suggest that the photochemical degradation of alkanes should be considered in studies of the fate of petroleum crudes in the marine environment.